Craftsman 315.101371 Operator's Manual page 8

UNPACKING
This product has been shipped completely assembled.
[] Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing
list are included.
A
WARNING: Do not use this product if it is not
completely assembled or if any parts appear to be
missing or damaged. Use of a product that is not
properly and completely assembled could result in
serious personal injury.
[] Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
[] Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
[] If any parts are damaged or missing, please call
1-800-932-3188 for assistance.
PACKING LiST
Hammer Drill with Auxiliary Handle Assembly
Depth Stop Rod
Carrying Case
Operator's Manual
_ WARNING: If any parts are damaged or missing do
not operate this product until the parts are replaced.
Failure to heed this warning could result in serious
personal injury.
A
WARNING: Do not attempt to modify this product
or create accessories not recommended for use with
this product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A
WARNING: Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious injury.
A
WARNING: Do not allow familiarity with the product
to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
A
WARNING: Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes and other possible serious injuries.
APPLICATIONS
You may use this product for the purposes listed below:
[] Drilling in all types of wood products (lumber, plywood,
paneling, composition board, and hard board)
[] Drilling in ceramics, plastics, fiberglass, and laminates
[] Drilling in metals
[] Driving screws
[] Hammer drilling in concrete, brick, or other masonry
VARIABLE SPEED SWITCH
See Figure 2, page i,
To turn the drill ON, depress the variable speed switch. To
turn it OFF, release the switch.
VARIABLE SPEED
The variable speed switch delivers higher speed and
torque with increased pressure and lower speed with
decreased pressure.
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
normal part of the switch function.
KEYLESS CHUCK
See Figure 2.
The drill-driver has a keyless chuck that makes it simple to
tighten or release drill bits in the chuck jaws. The arrows
on the chuck indicate which direction to rotate the chuck
body in order to LOOK (tighten) or UNLOCK (release) the
drill bit.
,_k WARNING: Do not hold the chuck body with one
hand and use the power of the drill to tighten the
chuck jaws on the drill bit. The chuck body could slip
in your hand, or your hand could slip and come in
contact with the rotating drill bit. This could cause an
accident resulting in serious personal injury.
FORWARD/REVERSE
See Figure 2, page i.
The direction of bit rotation is reversible and is controlled
by a selector located above the variable speed switch.
With the drill held in normal operating position, the direc-
tion of rotation selector should be positioned to the left
of the switch for drilling. The drilling direction is reversed
when the selector is to the right of the variable speed
switch.
8 - English