Advertisement
ASSEMBLY INSTRUCTIONS
Remove :I'RIMMER from carton and examine it thoroughly to
make sure It is not damaged.
Remove
and discard protective
plastic clips Inserted in
handle tubes before assembly of trimmer.
TOOLS NEEDED FOR ASSEMBLY
* Medium Phillips screwdriver
= Adjustable wrench or pliers
ATTACHING
THE ASSIST HANDLE AND TUBES
Attach the assist handle to the upper tube before jolnlngthe
tubes together(Fig. 1).
1: ..Theharness wire that" b.ex_sed
between the tubes will pass
• through the S_ot i n me bottom of_he assist handle.
"
2. Slide the handle up onto uppeft_be_
"
'
" .
3. Place bolt into handle, attach wingnut andtighten.
4: Slide lower_ube into upper tube and aE, gn holes.
5. Insert two screws through tubes, attach Iocknuts.and tighten
(Rg.2).
6. Adjust position of assist handle to conform to heightand arm
length.
RETAINING EXTENSION
CORD
Loop cord throughcord retainer and around hook (Fig. 3)
Insert cord socketinto recessed tdmmer plug.
BEFORE OPERAI_ING
Before.. u stngy_ur TRIMMER
:readand understand the RULES
FOR SA_
OPERATION
• Alwayswear SAFETY GOGGLES.
• ,Gut toyour LEFT side.
•
Keep people,away from you.
•
Inspectthe areasyouare goingtotrim forwires,cordand any
stdng4ik_e matter to prevent*themfrom gettingtangled in the
cutting' h ead.
CAUTION:
THE
CUTTING-BLADE
MOUNTED
IN THE
REAR
GUARD SECTION.
IS F-XTREMELY SHARP AND
CARE. SHOULD
BE EXERCISED
WHEN
.HANDLING
OR OPERATING
TRIMMER TO AVOID
CONTACT
WITH
G'UTrER.
._/MAIN
HANDLE
YRIGGERSWITCH ,
/
CuTn_G NF_O
t,/ l
°°"
FIG.2
FIG. 3
,OOK
F{G.I
3
Advertisement
