Advertisement
TROUBLESHOOTING
TABLE - Continued
TROUBLE
CAUSE
REMEDY
Oi_ inadequate
1. Oil tank empty.
1. Fill oil tank.
for bar and
2. Oil pump or oil filter
2. Contact Sears Service (see back cover).
chain
clogged.
lubrication.
3. Guide bar oil hole
3. Remove bar and clean.
blocked.
Chain moves at
1. Idle speed requires
1. See"CarburetorAdjustment"
in the
idle speed,
adjustment.
Service and Adjustments Section.
2. Clutch requires repair.
2. Contact Sears Service (see back cover).
Chain does not
1. Chain tension too
1. See"Check Chain Tension" in the
move when en-
tight.
Maintenance Section.
gine is acceler*
2. Carburetor requires
2. Contact Sears Service (see back cover).
ated.
adjustment.
3. Guide bar rails
3. Repair or replace.
pinched.
4. Clutch slipping.
4. Contact Sears Service (see back cover).
5. Chain brake engaged.
5. Disengage chain brake.
Chain clatters
1. Chain tension incorrect.
or cuts roughly.
Chain stops
within the cut.
Chain cuts at
an angle.
2. Cutters damaged.
3. Chain worn.
4. Cutters dull, improperly
sharpened, or depth
gauges too high.
5. Sprocket worn.
6. Chain installed
backwards.
1. Chain cutter tops not
filed flat.
2. Guide bar burred or
bent; rails uneven.
3. Clutch slipping.
1. Cutters damaged on
one side.
2. Chain dull on one side.
3. Guide bar bent or worn.
1. See "Check Chain Tension" in the
Maintenance Section.
2. Contact Sears Service (see back cover).
3. Resharpen or replace chain.
4. See "Chain Sharpening" in the
Service and Adjustments Section.
5. Contact Sears Service (see back cover).
5. Install chain in right direction.
1. See "Chain Sharpening" in the
Service and Adjustments Section.
2. Repair or replace guide bar.
3. Contact
Sears Service
(see back cover).
1. See "Chain Sharpening" in the
Service and Adjustments Section.
2. See "Chain Sharpening" in the
Service and Adjustments Section.
3. Replace guide bar.
If situations
occur which are not covered in this manual,
use care and good
judgement.
If you need assistance,
contact Sears Service or the CUSTOMER
ASSISTANCE HELPUNE at 1-800-235-5878.
YOUR WARRANTY
RIGHTS AND
OBLIGATIONS:
The U. S. Environ-
mental Protection
Agency and Sears,
Roebuck and Co., U.S.A., are pleased
to explain the emissions control system
warranty on your year 2002-2004
small
off-roed
engine.
Sears must warrant
the emission control system on your
small off-road engine for the periods of
time listed below provided there has
been no abuse, neglect, or improper
maintenance
of your small off-road en-
gine. Your emission control system in-
dudes parts such as the carburetor and
the ignition system. Where a wec_ant-
able condition exists, Sears will repair
your small off-road engine at no cost to
you. Expenses covered under warranty
include diagnosis, parts and labor.
MANUFACTURER'S
WARRANTY
COVERAGE:
If any emissions related
part on your engine (as listed under
Emissions Control Warranty Parts List) is
defective or a defect in the materials or
workmanship
of the engine causes the
failure of such an emission related part,
20
Advertisement
