Table of Contents
Advertisement
...........................................
,,, ,,i?,? _I;,L'_I_,:_??+_;,
i?,+i
';L,,, ; , i , : ;,' ' ,, + ,+ ........
r .......................................................
___P'
(_'too| is rece|vedas_embJed,
repeat all steps in thissecthm
to be sure assembly
is_
and is m_ijusted for the operator.)
This Operator's Manual has been developed to help you
assemble the tool and to provide its safe operation, It is
important thai you read the entire manual to become
familiar with the tool below you begin assembly
a+ Flathead Screwdriver+
b. 1-1/4 inch wrench or adjustable wrench+
c, Hex Wrench provided with tool+
............. 3,',' .......
B, AS._EMBLY
S_PS
1. D[_IVE $_
HOUSING -- Figure 1
a o Place the two Screws (from the loose parts bag) into
the holes on the Clutch Shroud as shown in Figure I
b, Position the Lock-Nuts
(from the loose parts bag)
in the hex openings in the Clutch Shroud,
c, Tighten theScrewswith the smatl hexwrench provid -
ed just enough to hold the hardware together while
holding the Lock-Nuts
with your other hand,,
NOTE: Dirt on the Shaft will significantly
reduce
the life of the tool, Ifrthe Flexible Drive Shaft falls
out of the Housing, clean, telube, then reinstall,
See "Flexible
Drive Shaft Lubrication"
in the
Maintenance
section
d Remove the shipping
cap fl'om the straight end
of the Drive Shaft Housing, Make sure the Flex-
ible Drive Shaft does not fall out of the Drive Shaft
Housing,
e
Align the bottom groove on the Drive Shaft Hous-
ingwiththe
Ridge on theinner,
lowerwallof
the
Clutch Shroud opening,
Turn the Arbor
Shaft as
necessary
to align the square end of the Flexible
Drive Shaft with the square inside the Clutch
Shroud opening+ Firmly
push the Drive
Shaft
Housing into the Clutch Shroud until it contacts the
Foam Grip or is within
I/8 inch+ Figure 1.
f. Tighten the Screws alternately
with the small hex
wrench until secure.
CLUTCH
SHROUD
' RIDGE
DRIVE SHAFI
HOUSING
GROOVE
+
I
I
I
I
t
®
Advertisement
Table of Contents
Troubleshooting
