Frigidaire GLD2875FPB0 Use & Care Manual page 6

Operating Instructions
(continued)
Options Selections
Hi-Temp Wash
When HI-TEMP WASH option is selected, the
dishwasher heats water in the main wash to
approximately 140°F (60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and soil
from dishes more effectively and aids in drying. HI-
TEMP WASH option can be used with all cycles
except CHINA CRYSTAL (some models) and
RINSE ONLY. HI-TEMP WASH is automatically
provided when ULTIMATE SCRUB cycle is se-
lected.
When HI-TEMP WASH option is selected, the light
above the pad wilt come on and remain on until
end of cycle. To turn off the HI-TEMP WASH
option, press the pad a second time. The light
above the pad wilt turn off.
Sanitize Option
To sanitize your dishes and glassware, select the
SANITIZE option. When selected, the light above
the pad will come on and remain on until end of
cycle. The water temperature in the final rinse will
be raised to 155°F (68°C) assuring bacteria is
destroyed. This option is available in Ultimate
Scrub, Normal and Econo cycles. Only these
sanitization cycles have been designed to meet
NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120°F (49°C).
The sanitize criteria may not be satisfied if there is
an interruption of the cycle, power failure or if the
incoming water temperature is below 120°F
(49°C).
To turn offthe SANITIZE option, press the pad a
second time. The light above the pad will turn off.
in your dish load that will not be completely dry at
the end of the cycle.
You may see water vapor coming from the vent
during the drying portion of cycle. The vent is
closed during washing to hold moisture and sound
inside. The vent opens during the last few minutes
of the final rinse and remains open for drying. The
drying option may be changed at any time during
the cycle and affects only the drying period.
Opening the door longer than one minute during
the dry cycle cancels the selected dry program.
Delay Start
The DELAY START option allows you to
automatically delay starting your dishwasher from
1-10, 1-24 or 2-4-6 hours depending on your
model.
On models with 1-10 or 1-24 hour delay, press the
DELAY START pad until the desired delay time
shows in the STATUS window. A light will come
on indicating the delay start hours and will remain
on until cycle starts.
To cancel the DELAY START option and begin the
cycle before the delay period is over, press the
START/CANCEL pad.
To Cancel a Cycle
You can cancel a cycle anytime during the cycle.
Press START/CANCEL pad and the dishwasher
will start a 90 second drain. At the end of the drain,
select the desired cycle.
Heat Dry
The HEAT DRY option in combination with rinse
aid will enhance drying performance. The energy
required to use the HEAT DRY option costs
pennies per cycle. You may choose not to select
the HEAT DRY option; however you will have items