To Adjust Choke Control; To Adjust Carburetor; Final Setting; Acceleration Test - Craftsman 917.271814 Owner's Manual

TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be
necessary. Check adjustment as de-
scribed below before loosening cable. If
adjustment is necessary, proceed as
follows:
1. With engine not running, move choke
control (located on dash panel) to full
choke position.
2. Remove air cleaner cover, filter and
cartridge plate to expose carburetor
choke (see "AIR FILTER" in the
Maintenance section of this manual).
3. Choke should be closed. If it is not,
loosen casing clamp screw and move
choke cable until choke is completely
closed. Tighten casing clamp screw
securely.
4 Reassemble air cleaner.
Choke Closed
Casing_
C,oko
TO ADJUST CARBURETOR
The carburetor has been preset at the
factory and adjustment should not be
necessary. However. minor adjustment
may be required to compensate for
differences in fuel, temperature, altitude or
load. If the carburetor does need adjust-
ment, proceed as follows:
In general, turning the mixture screw in
(clockwise) decreases the supply of fuel
to the engine giving a leaner fuel/air
mixture. Turning the mixture screw out
(counterclockwise) increases the supply
of fuel to the engine giving a richer fueVair
mixture.
IMPORTANT: Damage to the needles
and the seats in carburetor may resalt if
screw is turned in too tight.
PRELIMINARY SETTING -
1. Be sure you have a clean air filter, and
the throttle control cable and choke
are adjusted properly (see above).
2. With engine off turn idle mixture screw
In (clockwise) closing it finger tight and
then tam out (counterclockwise) 1-1/4
to 1-1/2 turns.
FINAL SE'_ING -
1. Start engine and allow to warm for five
minutes. Make final adjustments with
engine running and shift/motion
control lever in neutral (N) position.
2. With throttle control lever in slow
position, hold throttle lever against idle
speed screw and adjust idle speed
screw to obtain 1200 to 1400 RPM.
3. While still holding throttle lever against
idle speed screw, tum idle mixture
screw In (clockwise) until engine
begins to die and then turn out
(countemlockwise) until engine runs
rough. Turn screw to a point midway
between those two positions.
4. Continue to hold throttle lever against
idle speed screw an, d adjust idle
speed screw to obtain 900 to 1200
RPM. Release throttle lever.
ACCELERATION TEST -
5. Move throttle control lever from slow to
fast position. If engine hesitates or
dies, turn idle mixture screw out
(counterclockwise) 1/8 turn. Repeat
test and continue to adjust, if neces-
sary, until engine accelerates
smoothly.
High speed stop is factory adjusted. Do
not adjust - damage may result.
IMPORTANT: Never tamper with the
engine governor, which is factm'y set for
proper engine speed. Overspeedlng the
engine above the factory htgh speed
setting san be dangerous. If you think the
engine-governed high speed needs
adjusting, contact a Sears or other qualified
servicecenter, which has proper equip-
ment and experience to make any
necessary adjustments.
ldlo Speed
crew
Idle Mixture
Screw
hmttle Lever
IdleSpeed r-ff'"_::=:_'_%_
Screw
Throttle
L.v:
Idle
Mixture
Screw
28