Operation; Maintenance - Craftsman WEEDWACKER 358.795500 Instruction Manual

SWEEPING - The fanning action of
the rotating line can be used to blow
away loose debris from an area, Keep
the line parallel to and above the area
surface and swing the tool from side
to side.
Sweeping _
MAINTENANCE SCHEDULE
WARNING: Disconnect the spark plug before performing maintenance
except for carburetor adjustments.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels
Clean air filter
Inspect muffler and spark arresting screen
Replace spark plug
_ENERAL RECOMMENDATIONS
The warranty on this unit does not
cover items that have been subjected
to operator abuse or negligence. To
receive full value from the warranty,
the operator must maintain unit as
instructed in this manual. Various ad-
justments will need to be made peri-
odically to properly maintain your unit.
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Every 50 hours of operation
Yearly
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine per-
formance and increases fuel con-
sumption and harmful emissions. Al-
ways clean after every 5 hours of
operation.
1. Clean the cover and the area
around it to keep dirt from falling
into the carburetor chamber when
CHECK FOR LOOSE
FASTENERS AND PARTS
, Spark Plug Boot
* Air Filter
* Housing Screws
* Assist Handle Screw
* Debris Shield
CHECKFORDAMAGED OR
the cover is removed,
2. Remove parts by pressing latch to
release air filter cover.
NOTE: To avoid creating a fire hazard
or producing harmful evaporative
emissions, do not clean filter in gaso-
line or other flammable solvent.
3. Wash the filter in soap and water.
WORN PARTS 4.
Contact Sears Service Center for re- 5.
placement of damaged or worn parts.
• ON/OFF Switch - Ensure ON/OFF 6.
switch functions properly by moving
the switch to the OFF position. Make
sure engine stops; then restart en-
gine and continue.
• Fuel Tank - Discontinue use of unit if
fuel tank shows signs of damage or
leaks.
• Debris Shield - Discontinue use of
unit if debris shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
, After each use, inspect complete
unit for loose or damaged parts,
Clean the unit and labels using a
damp cloth with a mild detergent.
Allow filter to dry,
Add a few drops of oil to the filter;
squeeze the filter to distribute oil.
Replace parts.
_ilter
Cover Latch
REPLACE SPARK PLUG
Replace the spark plug each year to
ensure the engine starts easier and
runs better. Set spark plug gap at
0.025 inch. Ignition timing is fixed and
nonadjustable.
14