Craftsman 917.272951 Owner's Manual page 24

TO REPLACE MOWER BLADE DRIVE
BELT
Park the tractor on level surface. Engage
parking brake.
• Remove mower drive belt (See "TO
REPLACE MOWER DRIVE BELT" in
this section of this manual).
• Remove mower (See "TO REMOVE
MOWER" in this section of this
manual).
• Remove screws from R.H. mandrel
cover and remove cover. Unhook
spring from bolt on mower housing.
• Carefully roll belt off R,H. mandrel
pulley.
• Remove belt from center mandrel
pulley, idler pulley, and L.H. mandrel
pulley.
• Remove any dirt or grass which may
have accumulated around mandrels
and entire upper deck surface.
• Check secondary idler arm and idler to
see that they rotate freely.
• Be sure spring is hooked in secondary
idler arm and sway-bar bracket.
• Install new belt in lower groove of L.H.
mandrel pulley, idler pulley, and
center mandrel pulley as shown.
• Roll belt over R.H. mandrel pulley.
Make sure belt is in all grooves
properly.
• Reconnect spring to bolt in mower
housing and reinstall R.H. mandrel
cover.
• Reinstall mower to tractor (See
"INSTALL MOWER AND DRIVE BELT"
in the Assembly section of this
manual).
• Reassemble mower drive belt (See
"TO REPLACE MOWER DRIVE BELT"
in this section of this manual).
Left Hand Mower Center
Mandrel Blade Mandrel
Belt
Right Hand
Mandrel
Cover
Sway Bar
Bracket Screw
TO ADJUST ATTACHMENT CLUTCH
The electric clutch should provide, years
of service. The clutch has a built-in brake
that stops the pulley within 5 seconds.
Eventually, the internal brake will wear
which may cause the mower blades to
not engage, or, to not stop as required.
Adjustments should be made by your
nearest authorized service center/
department.
• Make sure attachment clutch and
ignition switches are in "OFF" position.
• Adjust the three nylon Iocknuts until
space between clutch plate and rotor
measures ,012" at all three slot
locations cut in the side of brake plate.
NOTE: After installing a new electric
c_utch, run tractor at full throttle and
engage and disengage electric clutch 10
cycles to wear in clutch plate.
__. Roar _
.
I t\ ClutchPlate_.0,2
Locknut (3)-'-'T-- I . _ake
,_-- _ Plate
24
TO ADJUST BRAKE
Your tractor is equipped with an adjust-
able brake system which is mounted on
the left side of the transaxle.
If tractor requires more than six (6.) feet
stopping distance at high speed an
highest gear, then brake must be ad-
justed.
• Depress clutch/brake pedal and
engage parking brake.
• Measure distance between brake
operating ann and nut =A" on brake ro_
• If distance is other than 1-3/4", loosen
jam nut and turn nut =A" until distance
becomes 1-3/4". Retighten jam nut
against nut =A".
• Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6)feet in highest gea=
further maintenance is necessary,
Contact your nearest authorized
service center/department.
With Parkin Brake "Engaged"
=_ Nut =A"
,,_,- Jam Nut