HOME CLEANING SYSTEM and CANISTER VACUUM CLEANER www.eureka.com For location of nearest Eureka Warranty Station or Service Information call 1-800-282-2886. Household Type Owner’s Guide 6700-6800 Series Index Important Safeguards ... 2 Service Information ... 4 Assembly & Use 6750-6799 ... 5 Assembly &...
Always turn off this appliance before connecting or disconnecting either hose or motorized nozzle. • Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using.
Page 3
CONSEILS DE SÉCURITÉ Lors de l’utilisation d’un appareil électrique, quelques précautions élémentaires doivent être observées, incluant les suivantes: LISEZ TOUTES LES INSTRUCTIONS AVANT D’UTILISER VOTRE ASPIRATEUR. AVERTISSEMENT Pour réduire le risque de feu, de choc électrique, ou de blessure: • Ne pas utiliser à...
Warranty Station. You should know the model, type and serial numbers when you call: If you prefer, you can write to The Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois 61701, USA. In Canada write to The Eureka Company, 866 Langs Drive, Cambridge, Ontario N3H 2N7.
HOW TO ASSEMBLE AND USE Canister Models 6750-6799 Series 1. Place tools in storage area. 2. Depress buttons on side of hose coupling; insert swivel hose until it locks in place. To remove hose, depress buttons on the side of hose coupling and pull up.
HOW TO ASSEMBLE AND USE Home Cleaning System Models 6877-6899 Series ® Power-Touch Handle Remote ON/OFF Selector for bare floor or carpet Carpet - push down on front *Off - middle Bare Floor - push down on back *Power ON/OFF can be controlled on some models from the Power-Touch handle switch or canister ON/OFF switch.
Page 7
Continued 7. Depress buttons on side of hose coupling; insert swivel hose until it locks in place. 8. Plug short adapter cord into handle. Push down on the plug until the clip snaps over the ridge on the inside of the handle.
Page 8
Quick Release System Instructions* * On Some Models 1. Snap interlocking wands together. 2. Slide Quick Release Lower Assembly into motorized nozzle handle socket. 3. Slide interlocking wands into Quick Release Lower Assembly. 4. Run electric cord along the rear of the interlocking wands and press into cord retainer.
Cyclonic Bag Saver. Your vacuum cleaner is equipped with three wands. Locate the short wand. Fig. 2a Line up the small hole at the top of the short wand with the arrow on the front of the cyclonic housing.
Page 10
Thoroughly dry the dust Nozzle compartment with a soft towel before using it again. If the cyclone unit clogs, use the vacuum cleaner to unclog it. Powerhead Unit the cyclone unit into the top of the long lower wand. Adjust the position of the cyclone unit.
Tools To use cleaning tools, attach directly to end of hose or use with a straight wand. Attach the circular end of tool to hose or wand with a twisting motion until it is secure. Dusting Brush Upholstery Nozzle Crevice Tool Floor Brush Dusting brush.
The bags are available (three in a package) from your local dealer, or you can call 1-800-282-2886 for other locations. Look for the package of GENUINE EUREKA FILTERAIRE dust bags – Style How To Change Style V Dust Bag...
6. Rotate brush roll 1/2 turn to make sure belt is self-centered onto the brush roll pulley. 7. Position hood; secure with screws (see Item 1 above). GENUINE Look for the EUREKA PRODUCT Use GENUINE EUREKA replacement belt, 58065. symbol. Motor Pulley Brush Roll Pulley...