Advertisement
The operation of any lawn
mower can result in foreign
objects thrown into the eyes,
which can result in severe eye damage.
Always wear safety glasses or eye shields
while operating your lawn mower or
performing any adjustments or repairs.
We recommend a wide vision safety mask
over spectacles or standard safety
glasses.
HOW TO USE YOUR
LAWN MOWER
ENGINE SPEED
The engine speed is controlled by a
throttle control located on the side of the
upper handle. Choke position is for
starting a cold engine and fast position is
for normal cutting, trimming, and better
grass bagging. Slow position is for light
cutting, trimming and fuel economy.
Fast
. -.s,ow
ENGINE ZONE CONTROL
_CAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST CUTTING
HEIGHT
• Raise wheels for low cut and lower
wheels for high cut.
• Adjust cutting height to suit your
requirements. Medium position is best
for most lawns.
• To change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure all wheels are in the
same setting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Lower Wheels for High Cut
Plate Tab
• _
Lever
RaiseWheels for. Low Cut
TO CONVERT
MOWER
Your lawn mower was shipped ready to
be used as a mulcher. To convertto
bagging or discharging:
REAR BAGGING
• Lift rear door of the lawn mower and
place the grass catcher frame hooks
onto the door pivot pins.
• To convert to mulching or discharging
•operation, remove grass catcher and
close rear door.
Pivot pins
SIDE DISCHARGING
• Rear door must be closed.
• Open mulcher door and install dis-
charge deflector under guard as shown.
• Mower is now ready for discharging
operation.
• To convert to mulching or bagging
operation, discharge deflector must be
removed and mulcher door must be
closed.
SIMPLE STEPS TO REMEMBER
WHEN CONVERTING
YOUR LAWN
MOWER
FOR MULCHING
-
• Rear door closed.
• Mulcher door closed.
FOR REAR BAGGING -
• Grass catcher installed.
• Mulcher door closed.
FOR SIDE DISCHARGING
-
• Rear door closed.
• Side discharge deflector installed.
7
ACAUTION:
Do not run your lawn
mower without rear door closed or
approved grass catcher in place.
Never
attempt to operate the lawn mower with
the rear door removed or propped open.
Advertisement
