Maintenance; Specifications; General Recommendations - Craftsman 580.768110 Operator's Manual

CUSTOMER RESPONSIBILITIES
MAINTENANCE SCHEDULE
RLL IN DATES AS YOU COMPLETE
REGULAR SERVICE
HOURLY OPERATING
INTERVAL
Eveiy 25 Every 100
Before Each Hours or Hours or
MAINTENANCE TASK Use Yearly Yearly
PRESSURE WASHER
Check/clean water inlet screen
on quick-connect. Xt
Check high pressure hose, X
Check detergent hose. X
Check spray gun and assembly for leaks. X
Purge pump of air and contaminants. X
ENGINE
Check oil level. X
Change engine oil. X*
Service air cleaner. X_
Clean/replace spark plug. X
Prepare for storage. Prepare unit for storage if it is to
remain idle for longer than 30 days.
SERVICE DATES
Clean if clogged. Replace if perforated or tom.
• Change oil after the first (2) operating hours and every 25 hours thereafter. Change sooner when operating under dirty or dusty conditions.
_' Replace more often under dirty or dusty conditions.
PRODUCT SPECIFICATIONS
Pressure Washer Specifications
PRESSURE ................................... 1900 psi
FLOW RATE ........................................ 2 GPM
DETERGENT MIX....Use undiluted detement
WATER SUPPLY
TEMPERATURE ........ Not to Exceed 140°F
Engine Specifications
ENGINE MODEL ............... Briqqs & Stratton
RATED HORSEPOWER ............................... 5
SPARK PLUG: Type: ...Champion RJ-19LM
or equivalent. Set
Gap to: _.0.030 inch
(0.76mm)
GASOLINE CAPACITY .......... 1.5 U.S. quart
OIL ........................................... SAE 30 weiqht
SOLID STATE ..................... 0.006 - .010 inch
IGNITION AIR GAP
In the State of California a spark arrestor is required
by law (Section 4442 of the California Public
Resources Code). Other states may have similar laws.
Federal laws apply on federal lands.
Note: If you equip the engine of your pressure washer
with a spark arrestor muffler, the spark arrestor must
be maintained in effective working order by the
owner/operator.
You can order a spark arrestor (PIN 398067) through
your Sears Service Center.
GENERAL RECOMMENDATIONS
Thp warranty of the high pressure washer does not
cover items that have been subjected to operator
abuse or negligence. To receive full value from the
warr_lnty, operator must maintain high pressure
washer as instructed in this manual.
Some adjustments will need to be made periodically to
properly maintain your high pressure washer.
All adjustments in the Service and Adjustments
section of this manual should be made at least once
each season.
• Once a year you should clean or replace the spark
plug and replace the air filter and check the gun
and wand assembly for wear. A clean spark plug
and new air filter assure proper fuel-air mixture and
help your engine run better and last longer.