Download Print this page

Craftsman 45-04381 Owner's Manual page 9

40" front mount tine dethatcher

Advertisement

CUSTOMER
RESPONSiBILiTiES
Read and follow the maintenance schedule and the maintenance procedures listed in this section.
MAINTENANCE
SCHEDULE
_.,/__/_o_/'_
_/"/
Fill in dates as you
.,,,i/_o_/:iA4 e_/_"
complete regular service.
//_/,_/_°_
y
Service Dates
CheckforloosefastenerSLubrication
xX
I I 1 I I I l I 1 I l
CHECK
FOR LOOSE FASTENERS
Before each use check all nuts and bolts for
tightness. Tighten loose fasteners before using.
LUBRICATION
Before each use apply a small amount of motor oil
between washer and wheel bearing and between
washer and top of axle bushing. See figure 16.
OIL
FIGURE 16
LIFT HANDLE
SMALL HAIRPIN COTTER_
LOCK
BRACKET
CLEVIS PIN
"LIFT HANDLE
BRACKET
OPERATING
TiPS
De-thatching is recommended for early spring, late fall and
prior to fertilizing. It is not recommended to de-thatch with
every mowing of the lawn. The tine dethatcher can be easily
removed for storage (Maintenance/Storage).
Always start with transmission in first (low) gear and
gradually increase speed as conditions permit.
Do not attempt to use dethatcher in field mowing.
For best results, use a "criss-cross" pattern on your lawn.
Vary vehicle speed to determine best speed.
The front and rear tines should be kept level.
Stop vehicle and lift dethatcher to transport position
when making sharp turns.
STORAGE
Always store in a dry area, and coat spring tines with
light oil when not in use.
TO REMOVE DETHATCHER
FROM TRACTOR
(Refer to figure 17).
Lower dethatcher to ground.
Remove 3/32" (small) hairpin cotter and 3/8" x 3/4"
clevis pin from lift handle. Remove handle from
handle lift bracket.
Slide lift handle out between lift handle arm and
handle lock bracket.
FIGURE 17
(Refer to figure 18).
Remove the two outside (large) 1/8" hairpin cotters
from mounting shaft and slide keeper plates off ends
of mounting shaft.
Lift dethatcher from hitch bracket slots.
Reassemble hairpin cotters and keeper plates to
mounting shaft for storage.
MOUNTING
SHAFT
SLOT
(LARGE) lm"
HAIRPIN COTTER
FIGURE 18
(LARGE) 1/8"
HAIRPIN
COTTER

Advertisement

loading