Craftsman 917.292391 Owner's Manual page 6

UNPACK CARTON & INSTALL
HANDLE
_, CAUTION: Be careful of exposed
staples when handling or disposing of
cartoning material.
IMPORTANT: When unpacking and
assembling tiller, be careful not to stretch
or kink cable(s).
• Cut cable ties securing handle column.
• Remove all packing from carton.
• Secure handle column to handle mount
using two (2) carriage bolts and two (2)
flange Iocknuts. Tighten both flange
Iocknuts securely.
• Remove packing material from handle
assembly.
• Route tine control cable through plastic
cable clip on handle column.
• insert plastic cable clip into hole in
handle column.
• Cut cable ties securing tiller to skid.
• Cut away carton and remove tiller from
skid by pulling backwards.
C Tine Control
7
: _-_®
Tine Control Cable (
Handle Mq
Tine
\ alves
qut "A"
Depth Stake
Stake
Bolt
Hex Bolts, Lockwashers,
and Hex Nuts
HANDLE HEIGHT
• Handle height may be adjusted to
better suit operator. (See "HANDLE
HEIGHT" in the Service and Adjust-
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better
handle your tilling conditions (See
"TINE ARRANGEMENT" in the Service
and Adjustments section of this
manual).
TINE OPERATION
• Check tine operation before first use.
(See "TINE OPERATION CHECK" in
the Service and Adjustments section of
this manual).
Bolts
Flange
Locknuts
INSTALL DEPTH STAKE
ASSEMBLY
• Loosen nut "A".
• Insert stake support between engine
bracket halves with stake spring down.
• Bolt stake support to engine brackets
with bolts, lock washers and nuts.
Tighten securely. Tighten nut "A".
• Depth stake must move freely. If it does
not, loosen support bolt.
6