To Adjust Gauge Wheels; To Operate Mower; To Operate On Hills; To Transport - Craftsman EZ3 917.272121 Owner's Manual

• Turn knob counterclockwise (,.3)to
lower cutting heighL
The cutting height range is approximately
1-1/2" to 4". The heights are measured
from the ground to the blade tip with the
engine not running. These heights are ap-
proximate and may vary depending upon
soil conditions, height of grass and types
of grass being mowed.
o The average lawn should be cut to
approximately 2-1/2 inches during the
cool season and to over 3 inches during
hot months_ For healthier and better
looking lawns, mow often and after
moderate growth_
• For best cutting performance, grass
over 6 inches in height should be
mowed twice° Make the first cut rela-
tively high; the second to desired height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted
when they are slightly off the ground when
mower is at the desired cutting height in
operating position. Gauge wheels then
keep the deck in proper position to help
prevent scalping in most terrain condi-
tions.
° Adjust gauge wheels with tractor on a
flat level surface°
° Adjust mower to desired cutting height
(See '%0 ADJUST MOWER CUTTING
HEIGHT" in the Operation section of
this manual).
o With mower in desired height of cut po-
sition, gauge wheels should be assem-
bled so they are slightly off the ground.
Install gauge wheel in appropriate hole
with shoulder bolt, 3/8 washer, and 3/8-
16 locknut and tighten securely.
o Repeat for opposite side installing
gauge wheel in same adjustment hole.
Gauge Wheel _
Mounting. _---_i-_
Bracket
"_,_
3/8-16 (_ _ 't.L "_.._
3/8 Washer_
Gauge Wheel ---"
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt by
the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine.
° Select desired height of cut.
• Lower mower with attachment lift con-
trol.
= Start mower blades by engaging attach-
ment clutch control.
° TO STOP MOWER BLADES - disen-
gage attachment clutch control.
Attachment Clutch
Switch Pull Out To
"Enga_ _
Push In To <--_
_Disengage" _ _Y
Attachment Lift Lever
High Position
/ Low
;_Position
_'\ Discharge
,_CAUTION: Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the discharge
guard in place.
TO OPERATE ON HILLS
_kCAUTION: Do not drive up or down
hills with slopes greater than 15 ° and do
not drive across any slope. Use the slope
guide provided at the back of this manual.
• Choose the slowest speed before start-
ing up or down hills.
° Avoid stopping or changing speed on
hills.
o If slowing is necessary, move throttle
control lever to slower position.
° If stopping is absolutely necessary, push
clutchlbrake pedal quickly to brake posi,-
tion and engage parking brake°
° Move motion control lever to neutral (N)
position.
IMPORTANT: The motion control lever
does not return to neutral (N) position
when the clutchlbrake pedal is depressed.
• To restart movement, slowly release
parking brake and clutch/brake pedal.
° Slowly move motion control lever to
slowest setting.
• Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission _bY p[a£!ng
freewheel control in freewheeling position.
Freewheel control is located at the rear
drawbar of tractor.
15