Craftsman 3One 917.373680 Owner's Manual page 6

BL_ : ¸'
Read these instructions and this manual in its entirety
before you attempt to assemble or operate your new lawn
mower. Your new lawn mower has been assembled at the
factory with the exception of those parts left unassembled
for shipping purposes. All parts such as nuts, washers,
bolts, etc. necessary to complete the assembly have been
placed in the parts bag. To ensure safe and proper
operation of your lawn mower, all parts and hardware you
assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightnessl
TO REMOVE LAWN MOWER FROM
CARTON
Remove loose parts included with mower.
- Cut down two end corners of carton and lay end panel
down flat.
o Remove all packing materials except padding between
upper and lower f_andle and 3adding hotding operator
presence control bar to upper handle.
Roll Jawn mower out of carton and check carton thor-
oughly for additional loose parts.
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD HANDLE (See Fig. 1)
iMPORTANT: UNFOLD HANDLES CAREFULLY SO AS
NOT TO PINCH OR DAMAGE CONTROL CABLES,
* Raise handles until lower handle section locks into
place in mowing position.
- Raise upper handle section into place on lower handle,
remove orotective padding and t_ghten both handle
knobs.
. Remove handle padding holding operator presence
controi bar to upper handle.
Your lawn mower handle can be adjusted for your
mowing comfort. Refer to "Adjust Handle" in the
Service and Adjustment section of this manual.
TO iNSTALL ATTACHMENTS
(See Fig. 2)
Your lawn mower was shipped ready to be used as a
mulcher. To convert to bagging or discharging:
* Open rear door and remove muicher plate. Store
mulcher plate Jn a safe place.
You can now install catcher or optional clipping deflec-
[or
To return to mulching operation, install mulcher plate
nto discharge opening of mower. Be sure all tabs are
seated property.
CAUTION: Do not run your lawn mower
without mulcher plate in place or ap-
proved clipping deflector or grass
catcher in place. Never attempt to op-
erate the lawn mower with the rear door
removed or propped open.
OPERATOR PRESENCE
CONTROLBAR
UPPER HANDLE
LIFT UP
LOWER HANDLE
FIG. 1
SLOTS
MOWING POSITION
/
J
/
J
/
J
f
f
/
MULCHER PLATE /
TABS
FIG. 2