Table of Contents
Advertisement
DRIVE CONTROL
• Self-propelling
is controlled by holding
the operator presence
control bar down
to the handle and pushing the drive
control lever forward
until it clicks; then
release the lever.
• Forward motion will stop when the
operator presence control bar is
released.
To stop forward
motion
without stopping engine, release the
operator presence
control bar slightly
until the drive control
disengages.
Hold
operator presence control bar down to
handle to continue mowing without self-
propelling.
• To keep drive control engaged when
turning corners, push down on handle
and lift front wheels off ground while
turning lawn mower.
Operator presence control bar
Drive
control
• Fill fuel tank. Use fresh, clean, regtJlar
unleaded gasoline with a minimum of 87
octane. Do not mix oil with gasoline.
Purchase fuel in quantities that can be
used within 30 days to assure fuel
freshness.
_,WARNING:
Experience indicates that
alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract
moisture which leads to separation and
formation
of acids during storage.
Acidic
gas can damage the fuel system of an
engine while in storage.
To avoid engine
problems, the fuel system should be
emptied before storage of 30 days or
longer. Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season.
See Storage Instructions for
additional information.
Never use engine
or carburetor cleaner products in the fuel
tank or permanent
damage may occur.
&CAUTION:
Fill to bottom of gas tank
filler neck.
Do not overfill. Wipe off any
spilled oil or fuel.
Do not store, spill or
use gasoline near an open flame.
To engage ddve
Drive control
control
disengaged
BEFORE STARTING ENGINE
OIL
Your lawn mower is shipped without oil in the
engine.
• Be sure mower is level and area around oil
fill is clean.
• Remove engine oil cap and fill to the full
line on the dipstick.
NOTE:
Allow oil to settle down into
engine for accurate dipstick reading.
• Engine holds 20 ozs. of oil. Fortype and
grade of oil to use, see "ENGINE" in
Maintenance
section of this manual.
• Pour oil slowly. Do not over fill.
• Check oil level before each use. Add oil if
needed.
Fill to full line on dipstick.
• To read proper level, tighten engine oil cap
each time.
• Reinstall engine oil cap and tighten.
• Change the oil after every 25 hours of
operation or each season.
You may need
to change the oil more often under dusty,
dirty conditions.
ADD GASOLINE
NOTE: Before filling fuel tank, remove and
discard the debris plug that is inside the
tank.
Gasoline filler cap
ngine oil cap
(Discard
debris plug)
TO START ENGINE
• To start a cold engine, push primer three
(3) times before trying to start. Use a firm
push. This step is not usually necessary
when starting an engine which has
already run for a few m'rnutas.
• Hold operator presence control bar down
to the handle and pull starter handle
quickly. Do net allow starter rope to snap
back.
• To stop engine, release operator presence
control bar.
NOTE:
In cooler weather it may be
necessary to repeat priming steps.
In
warmer weather over priming
may cause
flooding
and engine will not start. If you
do flood engine, wait a few minutes
before attempting
to start and do not
repeat priming steps.
8
Advertisement
Table of Contents
