Table of Contents
Advertisement
Solutions to Common Problems
SURFACE BURNERS DONOTLIGHT
Ill
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
Surface Control knob has not been completely turned to LITE. Push in and turn the
Surface Control knob to LITE until burner ignites and then turn control knob to
desired flame size.
,
Be sure gas supply valve is open.
Burner ports are clogged. Clean burners. See Cleaning the Burner Grates, Burner
Caps,Burner
Heads in General Care & Cleaning section. With the burner off, clean
ports with a small-gauge wire or needle.
•
Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord
is securely plugged into the outlet.
•
Electrical power outage (electric ignition models only). Burners can be lit manually.
See Setting Surface Controls
in this Use and Care Guide.
BURNER F_ME ONWLIGHTS _LF WAY AROUND BURNER
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
*
Burner ports are clogged. With the burner off, clean ports by using a small-gauge
wire or needle.
*
Moisture is present after cleaning. Lightly fan the flame and allow burner to operate
until flame is full. Dry the burners thoroughly following instructions in the General
Cleaning section.
BURNERFLAMEIS O_NGE
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
*
Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
*
In coastal areas, a slightly orange flame is unavoidable due to salt air.
Advertisement
Table of Contents
