Service And Adjustments; To Remove Mower; To Install Mower - Craftsman 917.276071 Owner's Manual

&
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER,
VICE OR ADJUSTMENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place gearshift lever in neutral (N) position.
3. Place attachment clutch in "DISENGAGED" position.
4. Turn ignition key to "STOP" and remove key.
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TRACTOR
TO REMOVE MOWER
1. Place attachment clutch in "DISEN-
GAGED" position.
2. If equipped, turn height adjustment
knob to lowest setting.
3. Lower mower to its lowest position.
4. Remove retainer spring holding
anti-sway bar to chassis bracket and
disengage anti-sway bar from bracket.
5. Remove four retainer springs from front
plate assembly and remove plate.
6. Remove retainer springs from suspen-
sion arms at deck and disengage arms
from deck.
7. Raise attachment lift to its highest posi-
tion.
8. Slide mower forward and remove belt
from electric clutch pulley.
9. Slide mower out from under right side
of tractor.
TO INSTALL MOWER
Be sure tractor is on level surface and
mower suspension arms are raised with
attachment lift control. Engage parking
brake.
Chassis
Bracket
Retainer
Spring
1. Swing anti-sway bar to left side of
mower deck.
2. Slide mower under tractor with deflec-
tor shield to right side of tractor.
IMPORTANT: Check belt for proper rout-
ing in all mower pulley grooves.
3. If equipped, turn height adjustment
knob counterclockwise until it stops.
4. Lower mower linkage with attachment
lift control.
5. Install belt into electric clutch pulley
groove.
6. Place the suspension arms on outward
pointing deck pins. Retain with double
loop retainer spring with loops up as
shown.
7. Install front plate assembly to tractor
suspension brackets and retain with
single loop retainer springs as shown.
8. Position front plate assembly between
front mower brackets. Raise deck and
plate assembly to align holes and
insert flanged pins. Secure pins with
double loop retainer springs between
the plate and mower brackets.
Front Mower Electric Clutch Pulley Front
Bracket Plate
Assembly
-Single Loop
Retainer
Springs
Double Loop
Retainer Springs
Front Mower
Bracket
Anti-Sway
Bar
Flanged Pins
USE PLIERS FOR
_ETAINER SPRING, _
*Up
Suspension Arm,,
Double Loop
Retainer Springs
(Outward pointing
deck pins)
19
Deflector Shield