Craftsman 3One 917.257562 Owner's Manual page 19

SERVICE AND ADJUSTMENTS
.... .................................. HIi ,11 ii1,1i
iii rl ilrll .r, _ i_,1 ............. , ii i ....................................
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
= Depress clutch/brake pedal fully and set parking brake,
= Place gearshift lever in neutral (N) position,
o Place attachment clutch in "DISENGAGED" position,
° Turn ignition key "OFF" and remove key.
= Make sure the blades and all moving parts have completely stopped,
° Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug,
HIll ........................ i j II, HI i .......................... i ,_ ii ii
TRACTOR
TO REMOVE MOWER (See Fig. 19)
Mowerwillbe easier toremove from the right side oftractor
- Place attachment clutch in "DISENGAGED" position,,
° Move attachment lift leverforward to lower mower to its
lowest position.
° Roll belt off engine pulley°
= Disconnect clutch rod from clutch lever by removing
retainer spring.
• Disconnect anti-sway bar from chassis bracket by
removing retainer spring,
= Disconnect suspension arms from rear deck brackets
by removing retainer springs.,
• Disconnect front links from deck by removing retainer
springs.
• Raise lift lever to raise suspension arms. Slide mower
out from under tractor,,
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE TRACTOR, THE
R,H, AND L.H. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR°
TO INSTALL MOWER (See Fig. 19)
• Raise attachment lift lever to its highest position.
° Slide mower undertractorwith discharge guard to right
side of tractor.
o Lower lift lever to its lowest position.
= Install mower in reverse order of removal instructions°
CLUTCH ROD
SUSPENSION
ARMS
RETAINER
SPRINGS
(BOTH SIDES)
FIG, 19
CLUTCH LEVER
RETAINER
SPRING
ENGINE
PULLEY
RETAINER
SPRINGS
(BOTH SIDES)
19