Craftsman 315.114852 Operator's Manual page 15

INSTALLINGBITS
See Figure 8.
[] Lock the switch trigger by placing the direction of
rotation selector in the center position.
[] Open or close the chuck jaws to a point where the
opening is slightly larger than the bit size you intend to
use. Also, raise the front of the drill slightly to keep the
bit from falling out of the chuck jaws.
[] Insert the drill bit.
,_ WARNING: Make sure to insert the drill bit straight
into the chuck jaws. Do not insert the drill bit into
the chuck jaws at an angle then tighten, as shown in
figure 9. This could cause the drill bit to be thrown
from the drill, resulting in possible serious personal
injury or damage to the chuck.
[] Tighten the chuck jaws securely on the bit.
NOTE: Rotate the chuck body in the direction of the
arrow marked LOCK to close the chuck jaws. Do not
use a wrench to tighten or loosen the chuck jaws.
DRILLB(T
CHUCK
UNLOCK COLLAR
(RELEASE)
CHUCK
JAWS
LOCK
(TIGHTEN)
CHUCK
BODY
RIGHT
REMOVING BITS
See Figure 8.
[] Lock the switch trigger by placing the direction of
rotation selector in the center position.
[] Open the chuck jaws.
NOTE: Rotate the chuck body in the direction of the
arrow marked UNLOCK to open the chuck jaws. Do
not use a wrench to tighten or loosen the chuck jaws.
[] Remove the drill bit.
Fig. 9
BIT STORAGE
See Figure 10.
When not in use, bits provided with the drill can be placed
in the storage area located on the base of the drill.
SCREWDRIVER
BIT
Fig. 8
BITSTORAGE AREA
Fig. I0
15