Warranty - Craftsman 580.752240 Operator's Manual

Add Engine Oil
1. Place pressure washer on a flat, ]eve]surface.
2. Cleanarea around oil fill and remove oil fii] cap/dipstick.
3. Using oil funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening.
HOTICE
Improper treatment of pressure washer can damage it and
shorten its life.
DONOT attemptto crankor startthe enginebeforeit hasbeen
properlyserviced with the recommended o il. This may resultin
an enginefailure.
4. Replace oil fill cap/dipstick and fully tighten.
Add FueJ
Fuel must meet these requirements:
* Clean, fresh, unleadedgasoline.
. A minimum of 87 octane/87 AKI (91 RON). High altitude
use, see High Altitude.
. Gasoline with up to 10% ethanol (gasohol) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
NOTICE
Avoid pressure washer damage.
Failureto follow Operator's Manual for fuel
recommendations voids warranty.
DONOTuseunapproved gasolinesuchas E85.
DONOTmix oil in gasoline.
DONOTmodifyengineto run on alternate fuels.
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. See Storage. All fuel is not the
same. if you experience starting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
WARHIHG
_ Fueland its flammable and
vapors are extremely
explosive.
Fire or explosion can cause severe burns or
death.
WHENADDINGFUEL
* Turnpressure washerOFF and let it coolat least2 minutes
beforeremovingfuelcap. Loosencapslowlyto relievepressure
in tank.
* Fillfuel tankoutdoors.
* DONOToverfilltank.Allowspacefor fuel expansion.
* If fuel spills,wait until it evaporates beforestartingengine.
* Keepfuelawayfrom sparks,openflames,pilot lights,heat,and
otherignitionsources.
* DONOTlight a cigaretteor smoke.
1. Cleanarea around fuel fill cap, remove cap.
2. Slowly add regular unleaded fuel (A) to fuel tank (B). Be
careful not to overfill. Allow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
3. Install fuel cap and wait for any spilled fuel to evaporate.