Assembly Of Push Block - Craftsman 171.25490 Owner's Manual

Farallrouting operations
a way from edge on the unaer-
side of workpiece, suctl as Gn3oving, Fluting, Veining,
Crown Molding, etc., at!act1f:ence using back hole and
the slot. See Figures 13 and 14 for avaitable fence
adjustment from the router bit center.
FIGURE 13,
21/2
2.
,
IJepenamg upon Ine roulsng operalton, insert one ol
the "2-20 x 1_/4 '' long carnage belts through one ot
the holes on the right side o! the of the table top (from
the underside) and the short slot in the fence. Make
sure square ol belt Fr_sinto square recess in table.
While hotding the bolt in place, install a _!:_"I.D. flat
washer and a large 1/,-20 knob onto the belt to
loosely secure the fence to the table.
4. Repeat Steps 2 and 3 for table slot and fence slot on
lhe left side of the table.
ASSEMBLY OF PUSH BLOCK
1,
Screw the small end of clamp rod into threaded hole
in clamp plate until the plate bottoms on it's shoulder
(make sure clamp is oriented such that letter "(3" is
facing outwards as shown in Figure 16.
.
,
Tightly secure clamp plate to clamp rod using V4"
helical lock washer and a hex nut.
Insert the opposite threaded end of clamp rod
lhrough hole in push block arid install a flat washer
and a wing nut onto it. (Refer to Figure 16.)
FIGURE 14.
1. Assemble unitized fence assembly to table as shown
in Figure !5.
\ 'Figure iS
1/,¢Helical Lock Washer 5/i,a" Flat
end Washer
Cramp Rod
Push Block
Clamp Plate
FIGURE 16.
WARNING; ROUTER VIBRATIONS SOMETIMES CAN
CAUSE V4-28 HEX NUT AND CLAMP PLATE TO GET
LOOSEt PERIODICALLY CHECK FASTENERS AND
CLAMP PLATE TO MAKE SURE THEY ARE TIGHT
AND SECURE.