Craftsman 917.28945 Operator's Manual page 25

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY
SERVICE OR ADJUSTMENTS:
I. Depress clutch/brake pedal fully and set parking brake_
2. Place gearshift lever in neutral position.
3_ Place attachment clutch in "DISENGAGED" position_
4_ Turn ignition key to "STOP" and remove key°
5. Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TO REMOVE MOWER
io Place attachment clutch in "DISEN-
GAGED" positiom
2o Lower attachment lift lever to its lowest
position.
3. Disengage belt tension rod (K) from lock
bracket (L).
CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and release
slowly.
4. Remove mower belt from electric clutch
pulley (M).
5_ Disconnect front link (E) from mower -
remove retainer spring and washer.
6. Go to eitherside ofmowerand disconnect
mower suspension arm (A) from chas-
sis and rear lift link (C) from rear mower
bracket (D) - remove retainer springs and
washers.
7. Go to other side of mower and disconnect
the suspension arm and rear lift link.
_, CAUTION: After rear lift links are discom
nected, the attachment lift lever will be spring
loaded. Have a tight grip on lift lever when
changing position of the lever.
8. From right side of mower, disconnect
anti-sway bar (S) from right rear mower
bracket (D) - remove retainer spring and
washer and pull mower toward you until
the bar falls from the hole in bracket.
9. "#drntractor steering wheel to the left as
far as it will go.
10. Slide mower out from under right side of
tractor°
TO INSTALL MOWER
Follow procedure described in "INSTALL
MOWER AND DRIVE BELT" in the Assembly
section of this manual.
25