Advertisement
iii
iiiii
i
1,1,11
ill,
iiii, i
ii1,1
......................................
...................
SERVICE AND ADJUSTMENTS
i
q
IIIIIHI
III
.......................................
I'1 ....................
I'
I
TO REPLACE
HEADLIGHT
BULB
ENGINE
•
Raise hood
TO ADJUST
THROTTLE
CONTROL
CABLE
•
Pull bulb holder out of the hole in the backside of the
(See Fig. 30)
grill°
The throttle control has been preset at the factory and
°
Replace bulb in holder and push bulb holder securely
adjustment should not be necessary
Check adjustment as
back into the hole in the backside of the grill
described below before loosening cable
tf adjustment is
•
Close hood
necessary, proceed as follows:
•
With engine not running, move throttle control lever to
fast (,_) position
•
Check that swivel is against side of quarter circle
If it
is not, loosen cable clamp screw and pull cable back
until swivel is against quarter circle°
Tighten cabIe
clamp screw securely
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly stop running or prevent it from starting
•
Check wiring. See electrical wiring diagram in Repair
Parts section of this manual
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-in fuse° The
fuse holder is located behind the dash
TO REMOVE
HOOD AND GRILL (See Fig. 29)
•
Raise hood
•
Unsnap headlight wire connector
=
Stand in front of tractor
Grasp hood at sides, titt
forward and lift off of tractor
•
To reinstall, slide hood pivot brackets into slots in
frame°
o
Reconnect headlight wire connector and close hood
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 29
TO ADJUST
CHOKE
CONTROL
(See Fig. 31)
The choke control has been preset at the factory and
adjustment should not be necessary
Check adjustment as
described below before loosening cable
If adjustment is
necessary, proceed as follows:
•
With engine not running, move choke control (located
on dash panel) to full choke (1\1) position
,
Remove air cleaner cover, filter and cartridge plate to
expose carburetor choke (see "AIR FILTER" in the
Customer Responsibilities
section of this manual)
,
Choke should be closed
If it is not, loosen casing
clamp screw and move choke cable until choke is
completely closed
Tighten casing clamp screw se
curelyo
,
Reassemble air cleaner
CLAMP
QUARTER
CIRCLE
SWIVEL
FIG. 30
CHOKE CLOSED
CAS{NG
CLAMP
SCREW
CHOKE
FIG. 31
23
Advertisement
