Installation; Parts Supplied - KitchenAid KSSS36MDX00 Installation Instructions Manual

l
base grille
l
miscellaneous parts bag
Check that all parts were included.
Product/Property Damage
l
Do Not lower the refrigerator
against the shipping base when
removing the shipping base.
l
Do Not remove protective film
until refrigerator is in operating
position.
l
All four leveling legs must
contact the floor to support and
stabilize the full weight of the
refrigerator.
l
Keep cardboard shipping piece
or plywood under refrigerator
until it is installed in operating
position.
Failure to follow these instructions
may cause damage to product or
floor covering.
1
Remove and save literature
ST package and parts bag taped to
refrigerator door. Remove four
brackets (two on each side) attaching
shipping base to refrigerator bottom.
Do Not remove tape and door
bracing until product is secured in
final location. See Page 3.
I
L. Place
appliance dolly
under
refrigerator 1
side and B
Insept carton corner posts between
strap and refrigerator at side trim
pieces and handles. Carefully tighten
strap making sure side trim and
handles are protected.
1
i
I
Personal Injury Hazard
. Because of the weight and size of
the refrigerator, two or more
people are required to install it.
l
Most of the refrigerator's weight
is at the top. Extra care is needed
when moving the refrigerator to
prevent tipping.
Failure to follow these instructions
could result in personal injury.
l/4" (6 mm)
(6
mm)
1 1
1/4"(6 mm)
compression
union
compression
nut nut
l/4"
(6
mm)
sleeve
3
Place sections of shipping carton
Slide a compression nut and sleeve on
. on the floor when rolling dolly
open end of each copper line. Use a
ind refrigerator into the house. Move
copper tubing union to connect both
.efrigerator close to built-in opening.
copper lines. Do Not overtighten.
4
Turn water supply valve to "OPEN"
jet'power switc
position. Turn refrigerator switch
"ON." Wait a few minutes. Check
at top of cabinet
to "OFF" position.
'lug power supply
:ord into
grounded outlet.
nstall retainer on
water line connection and water valve
on top of cabinet for leaks. Without
kinking the tubing, carefully place it
back underneath cabinet.
grounded outlet using
screw from parts bag.
5
Place top of cardboard
. carton or plywood under
refrigerator. Remove dolly. Open
appliance doors and remove all boxes,
parts packages and packing materials
from refrigerator and freezer
compartments. Do Not remove
protective film.
Move the refrigerator straight back and
evenly into the opening. Check that:
l
copper tubing is not kinked.
l
power supply cord is on top of
refrigerator next to cover.
Check that water supply line has
been flushed. See Page 7.
6
Pull copper line from refrigerator
. water valve and copper line from
plumbing forward from underneath
refrigerator. Remove cap from water line.
Page 8