Retaining Serial Numbers; Restoring The Serial Number Of The System Unit - Lenovo ThinkPad X130e Hardware Maintenance Manual

Hardware maintenance manual - x130e
Hide thumbs Also See for ThinkPad X130e:
Table of Contents

Advertisement

Notes:
• Make sure that you use the correct screw. If you have a torque screwdriver, tighten all screws firmly to the
torque shown in the table for each step in Chapter 8 "Removing and replacing a FRU" on page 49. Never
use a screw that you removed. Use a new one. Make sure that all of the screws are tightened firmly.
• Ensure torque screwdrivers are calibrated correctly following country specifications.

Retaining serial numbers

This topic provides instructions on the following:
"Restoring the serial number of the system unit" on page 46
"Retaining the UUID" on page 47
"Reading or writing the ECA information" on page 47

Restoring the serial number of the system unit

When the computer was manufactured, the EEPROM on the system board was loaded with the serial
numbers of the system and all major components. These numbers need to remain the same throughout
the life of the computer.
If you replace the system board, you must restore the serial number of the system board to its original value.
Before replacing the system board, save the original serial number by doing the following:
1. Install the LENOVO ThinkPad Hardware Maintenance Diskette Version 1.76 or later, and restart the
computer.
2. From the main menu, select 1. Set System Identification.
3. Select 2. Read S/N data from EEPROM.
The serial number of each device in your computer is displayed. The serial number of the system board is
listed is listed as 20: Serial number.
Write down that number.
Note: The serial number of the system board is also written on the label attached to the bottom of the
computer.
After you have replaced the system board, restore the serial number by doing the following:
1. Install the LENOVO ThinkPad Hardware Maintenance Diskette Version 1.76 or later and restart the
computer.
2. From the main menu, select 1. Set System Identification.
3. Select 1. Add S/N data from EEPROM. Follow the instructions on the screen.
If the MTM and Product ID numbers differ from each other on the rear label, use what is shown for the
Product ID field. See example below:
46
Hardware Maintenance Manual

Advertisement

Table of Contents
loading

Table of Contents