Macintosh Installation; Connect To The Computer; Network; Usb - Oki C7300 Software Installation Manual

Macintosh ®

Connect to the Computer

Network

!
®
Requires Mac OS 7.x or above, running on a
Macintosh computer with EtherTalk interface.
The Ethernet cable is not supplied with the printer.
Use an Ethernet crossover cable with RJ45
connectors at either end
Important!
Before connecting the network cable, install the
Ferrite Core. See Page 4 for instructions.
□ Turn the printer off.
□ Connect your Ethernet cable to the network port on
the printer server (1).
□ Connect the other end of the Ethernet cable to the
network port (2).
□ Turn the printer on and wait for the print server status
light (3) to stop blinking.
□ Press the Test button (4) on the print server. An
OkiLAN configuration sheet prints.
Installation

USB

!
No USB interface cable is supplied with the printer.
Use a USB cable that is compatible with USB
specification 1.1.
Notes:
• Requires Mac OS 9.04 or higher
• Printer operation is not assured if another USB
compatible device is connected concurrently with it.
• If a USB hub is used, it must be connected directly to
the computer.
• Depending on the size of the document, if the memory
setting for the print monitor is low, you may not be able
to print in the background. To correct for this, increase
the memory setting for the print monitor.
• Depending on the model you have, you may need to
install updates to the operating system in order to use
USB: e.g., iMac Update 1.0, iMac Update 1.1, iMac
Firmware Update, etc. For further information, contact
Apple Computers.
□ Turn the computer and the printer off.
□ Connect the USB cable to the USB port on the
computer (1).
□ Connect the other end of the cable to the USB Port on
the printer (2).
15