Hitachi XP P9500 User Manual page 220

3. Creating an HDLM Environment
• When
Root directory (
• When
Root directory (
Comment out the existing SCSI device specification by placing a hash mark (
at the beginning of each line, and then add the HDLM device specification as
shown below, based on the correspondence between the SCSI device and the
HDLM device as checked in step 17.
#/dev/sddlmaa2
#/dev/sda2
/dev/sddlmaa2
#/dev/sddlmaa4
#/dev/sda4
/dev/sddlmaa4
26. Shut down the host.
Execute the following command to shut down the host:
# shutdown -h now
27. Change the configuration from a single-path configuration to a multi-path
configuration.
28. Start the host.
29. Execute the
The following shows an execution example for when
loader:
# mount
/dev/sddlmaa2 on / type ext2 (rw)
/dev/sddlmaa1 on /boot type ext2 (rw)
/dev/sddlmaa4 on /tmp type ext2 (rw)
/dev/sddlmaa5 on /var type ext2 (rw)
196
is used as the boot loader:
GRUB
), ,
/ /boot /tmp
is used as the boot loader:
LILO
), ,
/ /tmp /usr
/ ext2
/ ext2
/ ext2
/tmp ext2
/tmp ext2
/tmp ext2
command to make sure that the HDLM device is mounted.
mount
:
:
, , ,
/usr /var swap
, ,
/var swap
:
:
defaults
defaults
defaults
:
:
defaults
defaults
defaults
:
:
GRUB
)
#
1 1
1 1
1 1
1 2
1 2
1 2
is used as the boot