Snmp Configuration; Xp Raid Manager Command Devices; Installation Roadmap - HP StorageWorks XP10000 - Disk Array Configuration Manual

SNMP configuration

The XP family of disk arrays and the SVS 200 support standard Simple Network Management Protocol
(SNMP) for remotely managing arrays. The SNMP agent on the service processor (SVP) performs
error-reporting operations requested by the SNMP manager. SNMP properties are usually set from
the SVP but they can also be set remotely using XP Remote Web Console or XP Command View
Advanced Edition Software. Refer to the applicable user's guide for procedures.
Figure 1 SNMP configuration
.

XP RAID Manager command devices

HP StorageWorks XP RAID Manager manages HP StorageWorks XP Business Copy Software or HP
StorageWorks XP Continuous Access Software operations from a host server. To use RAID Manager
you must designate at least one LDEV as a command device. This can be done with Remote Web
Console or XP Command View Advanced Edition Software. Refer to the applicable user guide for
information about how to designate a command device.
Creating scripts to configure all devices at once may save you considerable time.

Installation roadmap

Perform these actions to install and configure the disk array:
1. Installing and configuring the disk array
Setting the host mode and host group mode
Configuring the Fibre Channel ports
Setting the system option modes
2. Installing and configuring the host
Installing and configuring the FCAs
Loading the operating system and software
Clustering and fabric zoning
Fabric zoning and LUN security for multiple operating systems
3. Connecting the disk array
Restarting the Linux server
Verifying new device recognition
Defining the paths
XP Disk Array Configuration Guide for Linux 9