Installing And Configuring The Host; Loading The Operating System And Software; Installing And Configuring The Fcas; Clustering And Fabric Zoning - HP StorageWorks XP10000 - Disk Array Configuration Manual

Figure 2 Point-to-point fabric topology example
.
Table 2 Fabric topology settings
Fabric parameter
OFF
ON
ON
OFF

Installing and configuring the host

This section explains how to install and configure Fibre Channel adapters (FCAs) that connect the
host to the disk array.

Loading the operating system and software

Follow the manufacturer's instructions to load the operating system and software onto the host. Load
all OS patches and configuration utilities supported by HP and the FCA manufacturer.

Installing and configuring the FCAs

Install and configure the host bus adapters using the FCA manufacturer's instructions.

Clustering and fabric zoning

If you plan to use clustering, install and configure the clustering software on the servers.
Clustering is the organization of multiple servers into groups. Within a cluster, each server is a node.
Multiple clusters compose a multi-cluster environment. The following example shows a multi-cluster
environment with three clusters, each containing two nodes. The nodes share access to the disk array.
Connection parameter
FC-AL
Direct Fabric Attach
FC-AL
Direct Fabric Attach
XP Disk Array Configuration Guide for IBM AIX
Provides
NL-port (private arbitrated loop)
F-port (fabric port)
Not supported
Not supported
13