Mounting And Verifying The File Systems - HP StorageWorks XP10000 - Disk Array Configuration Manual

1. Use mkdir with the new mount directory name as the argument to create the mount directory.
Example
# mkdir /AHPMD-LU00
2. Use the ls
Example
The following example shows the root directory as the location for the mount directories.
# ls -x
AHPMD-LU00
floppy
3. Repeat above steps for each logical volume on the disk array.

Mounting and verifying the file systems

After the mount directories have been created, mount and verify the file system for each logical volume.
To mount and verify the file systems:
1. Use mount to mount the file system for the volume.
Example
# mount /dev/vg06/lvol1
2. Repeat step 1 for each logical volume on the disk array.
If you need to unmount a file system, use the unmount command.
3. Use the bdf command to verify that the file systems are correct. The capacity is listed under
Kbytes.
Example
# bdf
Filesystem
/ldev/vg00/lvol1
:
/ldev/vg06/lvol1
28 Installing and configuring HP-UX for the XP disk array
x command to verify the new mount directory.
bin dev
home hstsboof
/AHPMD-LU00
Kbytes used
59797 59364
2348177 9
device etc export
kadb kernel lib
avail %used Mounted on
0 100% /
2113350 0% /AHPMD-LU00