HP StorageWorks P9000 - Disk Arrays Manual page 264

Table 65 Error codes (part code 8105) (continued)
Part Error
Code Number
8105 1918
8105 1926
8105 1927
8105 2003
8105 2005
8105 2009
8105 2010
8105 201 1
8105 2013
8105 2015
8105 2082
8105 2083
8105 2084
8105 2097
8105 2204
8105 2205
8105 2504
264 Message (part code group 8nnn)
Error Message
An external volume is mapped to the
external port to be operated.
The path cannot be set to the specified
volume, because the volume is being
used as a quorum disk.
The specified volume cannot be set as a
command device, because it is being
used as a quorum disk.
An error occurred during SVP
processing.
An error occurred during SVP
processing.
An error occurred during SVP
processing.
The LDEV is being used by the host, or
an error occurred in the SVP procedure.
The status of the storage system requires
maintenance (for example, the storage
system is blocked, the shared memory is
inconsistent, or some other factor).
An error occurred during SVP
processing.
An error occurred while connecting to
the storage system.
Processing is disabled because the host
is mounted or the device is reserved.
The subsystem status is invalid.
The subsystem status is invalid.
The host specified by the WWN is
performing I/O operations.
Devices to be maintained include journal
volumes.
Devices to be maintained include journal
volumes.
No settings can be made because of a
volume reserved for RAID Manager.
Recommended Action
Delete the external volume that is
mapped to the external port to be
operated, then retry the operation.
Check the setting.
Check the setting.
Use the SVP to check if the DKC is in the
normal status, then retry. If the same
problem persists despite retrying, please
contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Recovery processing may take about 1
minute. Wait for a while.
Please contact HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If the same error occurs despite retrying,
please contact HP Technical Support.
Unmount the host and cancel reservation
of the device. If the host is an AIX host,
unmount the host, and execute the
varyoffvg command.
Check the DKC status and the current
status of the configuration setting. If
necessary, re-execute the setting
operation.
Check the DKC status and the current
status of the configuration setting. If
necessary, re-execute the setting
operation.
Check the settings, then retry the
operation.
Delete or suspend all pairs to which the
journal volumes belong.
Delete all pairs to which the journal
volumes belong.
Release the reserved attribute of the
target volume by using Data Retention.
Severity
Level
W
W
W
E
E
E
W
E
E
W
E
W
W
W
W
W
W