Advertisement
1. If local codes permit connection
of the frame ground-
ing conductor
to the neutral
(white wire), connect the
green
and white
wire from the supply
cable
of the
appliance
together
and to the neutral
(white) wire in
the junction
box. Connect
the remaining
wires from
the supply cable, matching
the colors, to the wires in
the junction
box.
2. If local codes DO NOT permit frame grounding
to the
neutral,
separate
the white
and green
wires
that
extend
out of the end of the supply
cable
of the
appliance.
Connect
the white
wire from the supply
cable to the neutral wire in the junction
box.
Connect the black and red wire from the supply cable,
matching
the colors, to the corresponding
wires in the
junction
box. The green wire MUST now be used to
ground
the appliance
in accordance
with local electri-
cal codes.
Connect
the green
ground
wire
to a
grounded
cold water pipe*or
to the grounded
lead in
the service panel. Do not ground to a gas supply pipe.
Do not
connect
to electrical
power
supply
until
appliance
is permanently
grounded.
Connect
the
ground
wire before turning
on the power. See Figure
2.
COPPER
GROUND WIRE
GROUNDED COLD
WATER PIPE
(REMOVE PAINT, ETC.)
GROUND CLAMP'
NUTS FIRMLY
(MUyNBp;p;yHT
FIGURE 2
*Cold water pipe must have metal continuity
to electrical
ground and not be interrupted
by plastic, rubber or other
electrically
insulating
connectors
(including
water meter
or pump) without
adding a jumper
wire at these connec-
tions.
CAUTION -
If connecting
to a four-wire
electrical
system
(MOBILE
HOME)
the appliance
frame
MUST
NOT be
connected
to the neutral
wire of the four-wire
electrical
system. Separate
the white and green wires that extend
out of the end of the supply
cable
of the appliance.
Connect
the white, red and black wires from the supply
cable, matching
the colors, to the corresponding
wires in
the junction
box. Connect
the green wire from the supply
cable to the ground
wire in the junction
box.
3. INSTALLATION
NOTE:
Before installing the oven in the cutout, it may be helpful
to remove the oven door. See details below.
Insert appliance
into cut-out. Screws are provided
for
fastening the front frame of the appliance to the cabinet.
The
mounting
holes
in
the
front
frame
of
appliance
may be used as a template
to locate the
appliance
mounting screw holes.
CAUTION:
For your personal
safety, and to minimize
potential
personal
injury, this oven must be securely
fastened to the cabinet,
using the four screws that are
provided.
Use caution when mounting
oven in cutout so you do
not overtighten
screws and cause porcelain
chippage
or puncture
oven cavity.
TO REMOVE OVEN DOOR-SELF-CLEANING MODELS
(Door to be removed for installation only).
1. Remove the two screws, one on each side of the inner door
panel. See View A.
SCREW (1
VIEW A
\
'
2. Put an allen wrench (5132" or smaller) or equivalent in the
hole in each of the hinges. Close the oven door until the
pins touch the oven front. See View 8.
3. The oven door can now be lifted off.
4. Reinstall oven door the same as on non-self cleaning
models. (See page 4)
5. Reinstall the door mounting screws.
3
Advertisement
