Table of Contents
Advertisement
Changing
Cooktop
and/or
Oven Lights
(if equipped)
Be sure the range is unplugged
and all parts are COOL before
replacing the surface or oven lights. Wear a leather-faced
glove for protection
against possible broken glass.
To Change the Cooktop
Light (some models)
I.
Turn power off at the main source or unplug the range.
2.
Remove Phillips® Head screws (2) that secure the light cover and then lift
the light cover off.
3.
Remove bulb by rolling back and up. Install the new bulb by sliding down
and rolling forward into place.
4.
Re-install light cover and secure with Phillips® Head screws (2).
To
Change
the
Oven
Light
(some Self Cleaning
Models)
On some models, the oven light automatically
turns on when the door is
opened. Some models have a switch located on the control panel to turn on
the light. The oven light is located at the rear of the oven and is covered with
a glass shield held by a wire holder. The glass shield must be in place whenever
the oven is in use.
To replace the oven light:
I.
Turn electrical power off at the main source or unplug the range.
2.
Press wire holder to one side to release the glass shield.
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder into place.
5.
Turn power back on again at the main source (or plug the range back in).
6.
The clock(if equipped) will then need to be reset. To reset, see Setting the
Clock and Minute Timer in this Owner's Guide.
Customizing
Your Oven
Performance
Note: The adjustments
made will not
change the se f-c ean ng temperature.
The temperature
in the oven has been set at the factory. When first using the
oven, be sure to follow recipe times and temperatures.
If you think the oven
is too hot or too cool, the temperature
in the oven can be adjusted.
Before
adjusting, test a recipe by using a temperature
setting that is higher or lower
than the recommended
temperature.
The baking results should help you to
decide how much of an adjustment
is needed.
To Adjust Oven Temperature
I.
Push [_.
2.
Set the temperature
to 550°F (287°C) by pushing and holding the _.
3.
Within
2 seconds, push and hold_"_
until the special 2 digit display
appears. Release 8"
The display now indicates the amount of degrees
offset between the original factory temperature
setting and the current
temperature
setting. If the oven control has the original factory calibration,
the display will read "00."
4.
The temperature
can now be adjusted up or down 35°F (I 7°C), in 5°F (I°C)
steps, by pushing and holding the_
or _.
Adjust until the desired
amount of offset appears in the display.
When
lowering
the
oven
temperature,
a minus sign (-) will appear before the number to indicate
that the oven will be cooler by the displayed amount of degrees.
5.
When you have made the desired adjustment,
push[_
to go back to the
time of day display.
19
Advertisement
Table of Contents
