Panasonic Omnivision VHS PV-VS4820 Operating Instructions Manual page 5

Between ANT. and VCR
F
• Case 1 : Twin Lead Cable Only
To VCR Terminal
From Antenna _@_
(Flat) Twin Lead Transformer
300 Ohm Cable (not supplied)
• Case 2: Twin Lead & Coaxial Cables
/ i U_HFNHF;andMixe_r_
J
(Round) 75 Ohm
coaxial Cable
To VCR Terminal
• Case 3: Two Twin Lead Cables
UHF/VHF Band Mixer _ \
(not supplied)
To VCR Terminal
• If your "IV has both post and plug-type
VHF terminals, the post connection is
recommended to minimize signal loss.
Note to CABLE system installer:
This reminder is provided to call the CABLE system installer's
sttenlJon to Adide 820-40 of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shell
be connected to the grounding system of the building, as close to
the point of cable entry as practica.
Between VCR and TV
• Case 1: Screw & Plug Type Terminal
UHF/VHF Band
TV
Separator
(not _/_(_--_-VHF
RF Coaxial Cable
• Case 2: Screw Type Terminal
TV
75-300 ohm
Transformer
(not supplied)
• Case 3: Double Screw Type Terminal
UHFNHF Band
TV
Separator
(not sup_ VHF
• Case 4: Complex TV Terminal
TERMINALS ON BACK OF "IV ,SET
Split out _"_""_T V
ANT2
• Connect to one of the ANT terminals and
select the same antenna number on the TV,
I FCC Warning: Any unauthorized changes or modifications to this equipment would void the user's authority to operate.
5