Advertisement
The Remote Control may be set up to control some TV or Cable/DSS Box functions.
Find your TV, Cable or DSS Receiver Brand
Code Number on following
page.
_ Q Q
Setup for TV
Q®Q
®
Setup remote.
Hold down TV and enter code
with NUMBERED keys.
Setup for Cable or DSS
_and
C) C) (_
®Q(9
OQ®
@Q
Hold down DSS/CABLE and
enter code with NUMBERED keys.
• For code100or greater,pressthe
100key first, then remaining d igit.
e.g. for 102,press 100,then press0,
andthen press2.
Confirm code entry.
Press POWER to turn
selected unitON or OFF.
• See table below for list of
controllablefunctions in each mode.
_1
• Please repeat Multi-Brand Control setup after replacing remote
control batteries.
• The remote control will not operate all TVs, Cable Boxes, and
DSS receivers made byrnanutacturers listed. If you get no
results, your particularbrand cannot be controlled.
3
POWER
2 ,er
DSS/CABLE
After remote control is setup, you can select VCR, TV, or DSS/CABLE for the desired function.
Press VCR or "r'v or DSS/CABLE
on the remote control.
This table shows which buttons are available for each mode.
Available
Mode _-._._s
VCR
VCR
All Functions
"rv
CABL_DSS
VCR/TV, PLAY, STOP
EJECT, DISPLAY, FF,
REW, PAUSE, SLOW,
REC, SPEED, ZERO/
1MIN, COUNTER
RESET
VCRFi'V, PLAY, STOP
EJECT, DISPLAY,FF,
REW, PAUSE, SLOW,
REC, SPEED, ZERO/
1MIN, COUNTER
RESET
TV
VOL UP/DOWN
POWER, INPUT,
NUMBERED keys,
ENTER, CH UP/DOWN,
VOL UP/DOWN
VOLUP/DOWN
CABL_ DSS
POWER, ENTER,
NUMBERED keys
(except 100key),
CH UP/DOWN
In TV or DSS/CABLE mode, it may be necessary to press ENTERafter pressing NUMBEREDkeys forchannelselection.
]4
Advertisement
