Table of Contents
Advertisement
Watching
TV
Cable
/ Satellite
/ Fiber
with
a box
Initial
setting
1.
Connecting
Select the wiring method connecting
your box to the TV, AV IN or
Antenna/Cable
in
I Tip: HDMI will provide the best HD picture I
2.
Change
INPUT
_
I INPUT
Press the INPUT button to select the proper connection.
Wait 2 seconds.
3. Power
on your
Cable,
Satellite
or Fiber
box
Use the box's remote control to change channels.
*
If the box is connected
to the TV using a COAX cable (Antenna/Cable
in), then
set the TV channel to CH3 or CH4. Note that the picture will not be in HD.
*
CC/SAP
is not available
when watching
TV with a Cable or Satellite box
connected
via HDMI.
If your box is a high definition,
then check that it is outputting
720p or 1080i
signal.
Tip: press the TV's _
button to verify.
Check your box "aspect"
or "format"
settings.
It should be set to 16:9,
Widescreen
or FULL.
If the audio volume is too low, check the box's audio settings.
Contact
your Cable or Satellite provider for instructions
on any box settings.
11
Advertisement
Table of Contents
