ASSEMBLY
CONNECT
BATTERY
(See Figs. 2 and 3)
CAUTION: Do not short battery termi-
nals.
Before connecting battery, re-
move metal
bracelets,
wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from acciden-
tal grounding.
•
Remove cardboard packing from seat pan and lift seat
pan to raised position.
•
Open battery box door:
•
Remove terminal protective caps and discard.
•
if this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
•
First connect RED battery cable to positive(+) terminal
with hex bolt, flat washer, lock washer and hex nut as
shown._ Tighten securely.
•
Connect BLACK grounding cable to negative (-) termi-
nal with remaining hex bolt, flat washer, lock washer
and hex nu[ Tighten securely_
•
Close battery box door.
Open battery box door for:
°
Inspection for secure connections (to tighten hard-
ware)°
.
Inspection for corrosion.
•
Testing battery.
•
Jumping (if required).
•
Periodic charging.
DISCARD
TERMINAL
POSITIVE
PROTECTIVE
(RED) CABLE
CAPS
HEX
WASHER
NUT
FLAT
WASHER
HEX
BOLT
NEGATIVE
(BLAC_
CABLE
SEAT
PAN
BOX DOOR
FIG. 3
INSTALL SEAT (See Fig. 4)
Adjust seat before tightening adjustment boil
•
Remove cardboard packing on seat pan
°
Place seat on pan and assemble shoulder bolt.
•
Assemble adjustment bolt, lockwasher and flat washer
loosely. Do not tighten_
•
Tighten shoulder bolt securely.
•
Lower seat into operating position and sit on seat.
°
Slide seat until a comfortable positionis reached which
allowsyou to press clutch/brake pedal all the way down
(See Fig_8)°
•
Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment bolt securely
SEAT
SEAT PAN
BOLT
FIG, 4
FLAT WASHER
LOCK WASHER
FIG, 2
8