Spur And Cup/Center Installation - Craftsman 113.228162 Owner's Manual

SPUR AND CUP/CENTER 1NSTALLATIOt_
1, Find a 3/4-16 hex nut among the loose parts and scr(_w
onto head stock spindle until finger tight,
3/4 16
HEX NUT
/
i!. |
2. Find two points and a spur ahd cup ct.m_er amo_g the
loose parts. To insert poir_t ir_to cer_ters, _)Jace cente_
between jaws of a vise. Do not ti£hte[_vice h_seq p[_i_
into center and with a hammer and r_ai_ ger_tly tap
around the base of the poh_t until secure
J
f
3, Insert spur center into head stock spir_dle and cup
center into tai;stock ram. NOTE: Do not drive or
hammer centers into spindte or ram as removal may be
difficult, Use a soft hammer or block of wood and give
them a gentle tap,
4. To remove spur center from spindle, hen the spindle
pulley with one hand, and, using a wrench or pair of
pliers, turn the hex nut counterclockwise until center
is ejected.
& To remove cup center insert a 1/4" wood dowe_ or brass
rod through the hole in the tailstock ram. Ho{d the
center with one hand and tap the dowet or rod with a
hammer.
\
CENTER
TAILSTOCK
RAM
FOOT