Epson Perfection V700 Photo User Manual page 6

Epson Perfection V700 Photo/V750 Pro
the side that faces up, as shown by the illustration on the
film holder. Make sure the entire image frame is positioned
in the film holder opening.
Note: Hold the edge of the film gently or use gloves to touch the
film; otherwise you may damage the film. Make sure the white
stickers on the back of the film holder and the areas around them
are not scratched, dusty, or covered in any way. If the areas are
obscured, the scanner may have trouble recognizing your film in
Full Auto Mode. Do not cover any of the tiny holes in the film
holder or the scanner may have trouble recognizing which film
holder you are using.
3. Close the cover over the film and press it down until it
clicks. Then press down on all the edges of the cover to
secure it.
4. Place the film holder on the document table so that it is
aligned with the upper right corner and the pins are seated
in the holes on the scanner.
5. Make sure you removed the document mat. See "Removing
the Document Mat" on page 4.
6 - Epson Perfection V700 Photo/V750 Pro
6. Close the scanner cover.
Note: You cannot use Full Auto Mode to scan medium format film.
When you are finished scanning film, be sure to replace the
document mat before scanning documents or photos. See
"Replacing the Document Mat" on page 9.
Placing 4 × 5 inch Film
1. Open the covers on the 4 × 5 inch film holder.
2. Place the film into the film holder with the shiny base side
facing down. Your images and any wording on the film
should appear backwards on the side that faces up, as shown
by the illustration on the film holder. Make sure the entire
image frame is positioned in the film holder opening.
Note: Hold the edge of the film gently or use gloves to touch the
film; otherwise you may damage the film. Make sure the white
stickers on the back of the film holder and the areas around them
are not scratched, dusty, or covered in any way. If the areas are
obscured, the scanner may have trouble recognizing your film in
Full Auto Mode. Do not cover any of the tiny holes in the film
holder or the scanner may have trouble recognizing which film
holder you are using.
3. Close the cover over the film and press it down until it
clicks. Then press down on all the edges of the cover to
secure it.
12/05