Recording From The Radio; Erasing Recorded Tapes - Sharp CD-MPS660E Operation Manual

Sequential recording from several discs:
1 Perform steps 1 - 5 in "Recording from a CD or MP3 disc" on page
28.
2 Within 5 seconds, press the / button.
To perform programmed recording:
1 Programme discs and tracks (see pages 19, 23).
2 Press the button.
3 Press the / button.
To stop recording:
Press the button.
The disc and tape will stop.

! Recording from the radio

1
Tune in to the desired station (see page 24).
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
Recording will be paused.
4
Press the / button to start recording.
To interrupt recording:
Press the button.
To resume recording, press the / button.
To stop recording:
Press the button.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
! Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
4
Press the button.
Recording will be paused.
5
Press the / button to start dubbing.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.

! Erasing recorded tapes

1 Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the dis-
play.
3 Press the button.
4 Press the / button to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
03/12/19 CD-MPS660E(A)3.fm
CD-MPS660E
TAPE 1 TAPE 2
29
TINSZA040AWZZ
6