Check List; Surround Sound - Sharp 21J-FH1RU Operation Manual

Colour television
Table of Contents

Advertisement

E11
USEFUL FEATURES (Continued)
TV / Video selection
Switches between TV broadcasts and AV input programmes.
• Each time you press the
, the input switches between
TV/VIDEO
AV1, AV2 and TV programme.

Surround sound

Produces a virtual surround sound from the TV's speakers.
Each time you press
, the mode changes
SURROUND
between ON , ON and OFF.
OFF : Produces normal sound.
ON
: Setting to this mode during stereo signal reception
produces a spacious sound, making the most of the
speakers' performance.
ON
: Setting to this mode during monaural signal reception
creates monaural sound that is similar to stereophonic
sound.
SURROUND
mode is not working if BALANCE in the SOUND menu is adjusted and not in centre (0).
Please see
Sound adjustment.
E8
AV1
TV/VIDEO
TV/VIDEO
1
2
3
AV2
4
5
6
7
8
9
0
25
CH
SECAM
D/K
CH
MENU
SURROUND
NORMAL
LANGUAGE
SURROUND
TV
SURROUND
OFF
SURROUND
ON
SURROUND
ON
E12
TROUBLESHOOTING
The following problems do not always indicate a hardware failure. Therefore, please use the
troubleshooting guide below before calling for repair service.
If, after following the guide none of the remedies work, unplug the TV set and call for service.
Quick
Service

Check List

Possible Causes/Remedies
Try a new channel to check for possible station
trouble.
TV not plugged in.
Outlet power OFF.
POWER switch of TV not ON.
Antenna not connected to terminal at the back
of the TV set.
If outside antenna is used, check for broken
wires.
Check for local interference.
Turn OFF using the
POWER switch,
then turn ON again after a minute.
Adjust COLOUR control.
Check batteries in the remote control.
Try fine tuning to correct.
Contrast setting in picture mode might be all
the way to the minus side. Press the
NORMAL button on the remote control to
correct.
Increase the volume.
This unit is equipped with a microprocessor. Its performance could be adversely affected by external
electrical noise or interference. If this should happen, unplug the unit and plug it in again after a few
minutes.

Advertisement

Table of Contents
loading

Table of Contents