Operation Instructions - Sharp AF-A077J Operation Manual

OPERATION INSTRUCTIONS

SPECIFICATIONS
Model
Rated A.C. voltage
Rated frequency
Cooling Capacity
Rated input power
Rated current
PRECAUTIONS
POWER CORD REPLACEMENT
WARNING: For replacement, use only the manufacturer specified power cord as shown
below.
Model
AF-A077J,AF-A097J,AF-A127J
Replacement should be conducted by a service centre approved by Sharp.
WAIT FOR 3 MINUTES BEFORE RESTARTING THE COOLING OPERATION
Whenever you turn the air conditioner OFF, wait for at least three (3) minutes before
restarting the unit.
If you restart the air conditioner within three minutes, a protective device in the unit may
cause the air conditioner to shut off. This protective device will prevent cooling operation
for about 20 minutes.
IF A POWER FAILURE OCCURS DURING OPERATION, MAKE SURE TO TURN OFF THE
AIR CONDITIONER
After resumption of power supply, restart the air conditioner . If the power was off
for less than three minutes, make sure to wait for at least three minutes before re-
starting the unit.
If the air conditioner is not turned off during a power failure, the resumption of power
supply will cause excessive voltage. The air conditioner will be over-loaded and will
not operate for about 20 minutes.
TO STOP THE UNIT, TURN THE SELECTOR KNOB TO THE "OFF" POSITION.
ALWAYS USE A FUSE WITH THE PROPER AMP RATING
Never use wire, pins or anything other than the proper fuse. The product may be
damaged and fire or other hazards may be resulted. In replacing a blown fuse, or if there
is the problem of constant fuse blowing, contact your dealer or our service centre.
VENTILATE THE ROOM PERIODICALLY DURING USE, ESPECIALLY IF GAS APPLIANCES
ARE USED.
AF-A077J 2çZ-2
AF-A077J
2.05kW
820W
3.7A
Power cord parts code
QACC-A231JBE0
6
OPERATION INSTRUCTIONS
AF-A097J
230-240 V
50Hz
2.64kW
1050W
4.6A
5
98.1.6, 0:11 PM
AF-A127J
3.50kW
1400W
6.3A