Changing Settings Using A Web Browser (Web Control); Displaying Web Control; Projector Setup - Epson G5150Nl Operation Manual

Changing Settings Using a Web Browser (Web Control)

You can set up and control the projector from a computer by using the
Web browser of a computer that is connected to the projector via a
network. Setup and control operations can be performed remotely if
this function is used. In addition, since you can use the computers
keyboard, entering characters required for the setup is easier.
Use Microsoft Internet Explorer 6.0 or later as the Web browser. If
using a Macintosh, you can also use Safari.
If, however, you are using Safari under Macintosh 10.2.8, some of the
Web control radio buttons may not display properly.
Setup and control with a Web browser are possible if set to
q
"Network ON" from the "Extended" menu of the
projector's configuration menu, even if the projector is in
standby mode (when the power is off).

Displaying Web Control

Display Web control with the following procedure.
If your Web browser is set up to connect via a proxy server,
q
Web control cannot be displayed. To use the Web control,
you need to make network connection settings with a
different method than a proxy server.
Entering the IP address of the projector
f
Web control can be opened by specifying the IP address of the projector
as follows when using "Advanced Connection Mode".
Procedure
A
Start the Web browser on the computer.
B
Enter the IP address of the projector in the address
input box of the Web browser, and press the [Enter]
key on the computer's keyboard.
Web Control is displayed. If you have set a Web Control password
in the projector, you will be asked to enter a user name and
password. enter "EPSONWEB" for the user name.

Projector Setup

You can set items that are usually set in the projector's configuration menu
The items available in Web Control are the same, with the exceptions
noted below.
Items in the configuration menu that cannot be set by the
f
web browser
All items in the configuration menu can be set with the exception of the
following items.
• "Signal" - "HDMI Video Range"
• "Settings" - "Keystone" - "Quick Corner"
• "Settings" - "Pointer Shape"
• "Settings" - "User Button"
• Registering a user's logo using "Extended" - "User's Logo"
• "Extended" - "Operation" - "High Altitude Mode" and "BNC Sync
Termination"
• "Extended" - "Language"
• "Reset" - "Reset All", "Reset Lamp Hours"
the MAC Address is not displayed in Web Control.
Additionally,
43