Leds On The Sfp Media Side - HP StorageWorks 8B - FC Entry Switch Getting Started Manual

LEDs on the SFP Media Side

36
• Two Ethernet port LEDs, one to show link speed and one to show link
status.
Figure 18 shows the SFP media side of the switch with the LEDs identified.
Figure 18. The SFP Media Side of the FC Entry Switch 8B and FC Switch 8B
The LEDs may flash different colors during diagnostic tests and
Note
POST. This does not indicate a problem unless the LEDs do not display a
healthy pattern after POST or the other diagnostic tests are complete.
The following table describes the switch status LED located to the right of
the serial port on the SFP media side of the switch.
Color of LED Status of Hardware
No light Either the switch is off, or boot
is not complete, or boot has
failed.
Steady green Switch is on and all ports are
ready for use.
Recommended Action
Verify that the switch
is on and boot has had
time to complete. If
there is still no light,
contact HP support.
No action required.
Getting Started Guide