Advertisement
Tools
Necessary:
and
Fiat Head
Screw Driver
m
Door
Lower
•
i
Screws
_''_
TO D|SCONNECT
1. Press outer ring against
face
remove TUDe
push ur_til mark touches
face of fitting
DOOR
REMOVAL
iNSTRUCTiONS:
if it is necessary
to move the refrigerator
through
narrow doorways,
follow
these steps to remove the doors.
Before
you start:
1 Make sure the electrical power cord is unplugged from the wall outlet.
2 Remove any food from the door shelves.
3 Close the doors.
To remove
the hinge
cover:
1 Remove the three screws from the cover over the top door hinges.
2 Pull the cover forward about a half inch and lift it off.
To remove
the refrigerator
door:
1 Trace lightly around the door's top hinge with a pencil. This makes reinstallation
easier
2 Remove the two screws from the top hinge. Lift the door off of the bottom hinge and
set it aside.
3 Remove the three bottom hinge screws and hinge, if necessary.
To remove
the freezer
door:
1 Detach the multi-wire cable connector located above the top hinge. Grasp both sides
of the connector firmly and pull apart.
2 Trace lightly around the door's top hinge with a pencil. This makes reinstallation
easier
3 Detach the water tube from the connector located below the freezer door. The
connector releases when you press its outer sleeve inward.
4 Remove the screws from the top hinge and pull the multi-wire cable through it.
5 Lift the door off of the bottom hinge. Lay the door on its side to avoid damage to the
Remove the three bottom hinge screws and hinge, if necessary.
To reinstall the refrigerator and freezer doors, reverse the above steps.
Screws
Advertisement
