Table of Contents
Advertisement
Operating
(continued)
Instructions
ADDITIONAL
THINGS
YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with.
//_
• The "Cool"
circuit
has an automatic
3 minute
time
delayed
start
if the unit is turned
off and on quickly.
This prevents
overheating
of the compressor
and possible
circuit
breaker
tripping.
The fan will continue
to run during
this time.
•
There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility of having
to roll through to select another mode.
• The control will maintain the set temperature
within 2 degrees Fahrenheit, between 60F and 90F degrees.
o After a power outage, the unit will memorize the last setting and return the unit to the same setting once power is restored.
]
Figure 1 (VENT CLOSED)
i
]
Figure 2 (FRESH ATR)
Fresh Air Vent Control
(on some models)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (see Fig. 1)
2. Draw fresh air into the room - Fresh Air (see Fig. 2)
3. Exchange air from the room - Vent Open (see Fig. 3)
.....
i
.............. :::!:
-_- _
i
i
Figure 3 (VENT OPEN)
AUGER WHEELS
(8-WAY)
Air Directional
Louvers
Air directional
louvers control air flow direction. Your air conditioner
has the louver
type described below.
Auger Type
The louvers will allow you to direct the air flow Up or Down and Left or Right
throughout
the room as needed. Rotate the Auger Wheels until the desired
Left/Right direction is obtained. Pivot horizontal louvers until the desired
Up/Down direction is obtained.
Advertisement
Table of Contents
