Epson PowerLite 7800p Product Information Manual page 21

EPSON PowerLite 7800p Projector
Follow these steps to replace the lamp and air filters:
1. Turn off the projector.
2. When the P power light stops flashing, unplug the power
cord.
3. Let the projector cool for at least half an hour (if it has been
on). The lamp is extremely hot immediately after use.
4. Turn the projector upside-down and remove the air filters
at the side and bottom of the projector.
Lower the
handle
5. Insert the two new air filters. They should click into place.
6. To remove the lamp cover, insert the screwdriver supplied
with the spare lamp (or another flat-tipped screwdriver),
into the space beside the air vent to gently lift the lamp
cover off.
Insert the screwdriver here
20 EPSON PowerLite 7800p Projector
-
Slide the filter
up here . . .
. . . and here
1
7. Loosen the two screws holding the lamp in place. (You
don't need to remove them.)
8. Grasp the wire handle as shown and pull the lamp straight
out.
9. Gently insert the new lamp.
10. Once the lamp is fully inserted, tighten its screws and
replace the cover. (The projector won't come on if the lamp
cover is loose.)
11. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer
using the projector's About menu.
1. Press the button on the remote control or the
Menu
projector's control panel to display the main menu.
2. Use the pointer button on the remote control (or the
arrow buttons on the projector) to highlight
press .
Enter
5/03
, then
About