Solving Problems With The Image Or Sound - Epson PowerLite 600p User Manual

Solving Problems
72
Solving Problems with the
Image or Sound
No image appears on the screen.
Check that the P power light is green, not flashing, and the lens
I
cap is off.
The projector may be in sleep mode. If the P power light is
I
orange, press the
Power
I If the power was switched off and then on again, the projector
may still be cooling down. Wait until the power light stops
flashing and remains orange; then press the
Try pressing the
I Power
I Make sure the
Brightness
See page 46 for more information. Try selecting the
setting to return all setup menus to their default values.
Press the
I A/V Mute
turned off temporarily.
The attached computer may be in sleep mode or displaying a
I
black screen saver. Try pressing a key on the computer.
You see a blue screen with the message
Make sure the cables are connected correctly, as described in
I
Chapter 1.
I Try restarting your computer.
If you've connected a computer and one or more video sources,
I
you may need to press the
(on the projector) or the
button (on the remote control) to select the correct
S-Video
source. Allow a few seconds for the projector to sync up after
pressing the button.
button to turn the projector on.
button on the remote control.
setting on the Video menu is correct.
button to make sure the picture has not been
No Signal
Computer/YCbCr
,
Comp1 Comp2/YCbCr
button again.
Power
Reset All
displayed.
or button
Video
, , or
Video