Resetting The Lamp Timer; Transporting The Projector - Epson PowerLite 6110i User Manual

Epson PowerLite 6110i
4. To release the lamp cover, insert the screwdriver included
with the new lamp as shown, then remove the cover.
5. Loosen the two screws holding the lamp in place (you can't
remove them).
6. Pull the lamp straight out.
Note: The lamp(s) in this product contain mercury. Please
consult your state and local regulations regarding disposal or
recycling. Do not put in the trash.
7. Gently insert the new lamp.
14
8. Once the lamp is fully inserted, tighten its screws and
replace the cover. (The projector won't come on if the lamp
cover is loose.)
9. Reset the lamp timer as described in the next section.

Resetting the Lamp Timer

After you replace the lamp, you need to reset the lamp timer
using the projector's menu.
1. Plug the projector in and turn it on.
2. Press the button on the remote control, select
Menu
from the Reset menu, then press
Lamp Hours
Note: The lamp usage timer shows 0H until you've used the
lamp for at least 10 hours.
3. When you see the confirmation message, select
press .
Enter
4. When you're finished, press

Transporting the Projector

The projector contains many glass and precision parts. Follow
these guidelines to prevent injury or damage:
❏ When hand-carrying the projector, you should use the
handle to lift it only a short distance (for example, to set it
on a table).
❏ When shipping the projector for repairs, use the original
packaging material if possible. If you do not have the
original packaging, use equivalent materials, placing plenty
of cushioning around the projector.
❏ When transporting the projector a long distance, first place
it in a hard-shell shipping case, and then pack it in a firm
box, placing cushioning around the case.
Note: Epson shall not be liable for any damages incurred during
transportation.
12/07
Reset
.
Enter
, then
Yes
to exit the menu system.
Menu